GSK AC Servo Motor and Driver User:

We have purchased a servo (130SJT-M075E(A2)) and a GS2000 AC Servor controller (GS2050T-NP1) a while ago.
We are no trying with manual mode to get the thing running.
With all the parameters correctly set like:

PA1: 64
PA118: 1
PA4: 9

now, if we go to manual run in SR, we get an "error 6" shortly after it moves for just a bit.

We checked the wiring U;V;W and everything else.
Also the motor type should be correct with PA1:64

The axis is freely moving, and not blocked or so. So there is no problem there

We also tried jog mode, but got the same Error 6

Can you help us with this problem?

Thank you in advance.

CNCmakers Support:
Please raise the values of PA133, PA134, PA135 and PA136 and try again.