We have purchased a servo (130SJT-M075E(A2)) and a GS2000 AC Servor controller (GS2050T-NP1) a while ago.
We are no trying with manual mode to get the thing running.
With all the parameters correctly set like:
PA1: 64
PA118: 1
PA4: 9
now, if we go to manual run in SR, we get an "error 6" shortly after it moves for just a bit.
We checked the wiring U;V;W and everything else.
Also the motor type should be correct with PA1:64
The axis is freely moving, and not blocked or so. So there is no problem there
We also tried jog mode, but got the same Error 6
Can you help us with this problem?
Thank you in advance.
