Products Catalogue Home     |     About Us    |     Retrofit     |     Download     |     News     |     Tech Support     |     Contact Us     |     
ppr fittings-NF-4011-Newsun Industry Co., Ltd
Home > Tech Support >

Overtravel Alarm 0511 0510

 GSK218MC-H User:

Kindly, when we run the X axis on the V8new cnc, the table could reach the limits and continue running, even if we have overtravel alarm.
 
Is this normal to have the table continue after the limit reached ? See attached.
 
Note that, in the wiring, both X limit microswitches are connected in series, going to both X0.0 and X0.1 inputs, and we have two alarms when we press one microswitch.
 
CNCmakers Support:
In the wiring, both X limit microswitches can not be connected in series, going to both X0.0 and X0.1 inputs, must separated.
 
 
 
 
 

—[Close]— —[ Back]— —[ Print]—