4 Station tool post LDB4-57B(6125) user:

As you remember that we purchased Auromatic Tool Changer from you. We are facing problem after fitting of tool changer. The upper body of tool changer moves slightly by the hand or even by touching it. The upper body should remain firmly fixed unless rotated by motor. Kindly suggest any possible solution for this problem.

CNCmakers Support:

The shaft inside must be broken by crash.

Need to replace it.

4 Station tool post LDB4-57B(6125) user:

But when we provide power to the motor. The tool changer rotates. How the shaft could be broken in this case?

CNCmakers Support:

To find out if the shaft is broken or not, you can do below steps:

1- Take out the aluminium cover on top.

2- Try to rotate the inductive sensor 14/15T

If the sensor can be rotated, that means the shaft is broken.