CNC Plasma Kit User:
I 'm starting to assemble the CNC cutting table with CNC6500 flame/plasma cutting control . Please help me with the following:
Reading the Manual of THC observed that  need DC lifting motor , It’s  does not come with the kit .  should I buy it ? If so please comment me the basic characteristics to buy  .
The kit comes with 3 motor  are for x, y , z . Question : z is not in control of THC ? Please could you tell me the use of each motor shipped?
I appreciate your prompt response.
I appreciate your prompt response. When  have more questions  I call you.
 

CNCmakers Support:
Yes, the DC brushless motor is not included, normally we use 60VA motor here, and the two cables must be exchangeable.
For example, there are two cables for the motor, one red and one black.
When the red one connect to the +24V, and the black one connect to the 0V, the motor rotates forward.
When the red one connect to the 0V, and the black one connect to the +24V, the motor rotates backward.

The Z axis is controlled by THC HCA1002 (torch-height-control).
The 3 motors you can use 2 motors for X axis, and the other for Y axis.