Realize the automatic feeding and processing of various shapes and sizes of compressor parts on the production line.

 

 

 

solution

 

 

According to the requirements of parts processing, each kind of workpiece is composed of 4 sets of 988TR. The production line is used for loading and unloading and feeding through the truss to complete the processing of a workpiece;

Each production line sets the number of processing according to the needs. After the number of processing is reached, an external alarm will prompt the quality inspector to check, and normal production after manual confirmation;

Using the tool life function, each tool is set with a service life, and it prompts to change the tool pellet after reaching it;

There are 16 production lines on the fourth floor of this workshop, and 12 production lines on the third floor with a total of 112 988 TR systems, which work continuously for 24 hours.

 

 

 

Application effect

 

 

It is mainly used in the processing of various parts of compressors, reducing the number of operators as much as possible, making full use of the truss automatic feeding and feeding; forming a close-to-automatic production line, adapting to the processing of various compressor parts. The processing cost is greatly reduced, and the processing efficiency is greatly improved.