Error 17 on GE2100T-LA1

GSK218MC and GE2000T-LA1 User:

Hi,

I think we have found out of the Error 17 on the servo drivers.

We have connected the servo driver as the manual says, but when we switch on the main power on we get the error 17.

Then only terminals r and t get power until we press the On switch.

If we hold the On switch in when we turn the power on it is ok.

Then the terminals r t K S and T get power simultaneous.

How is it supposed to be wired?

CNCmakers Support:

Connect T to t, Connect R to r. by parallel connection

Then connect input power 220V/3phase to R S T