Question: 
Is the offer for the A or B configuration with network connection?
Answer:
The offer is B type.

Question:
One more question came up with the customer regarding G codes.
They need to have kerf compensation G40 and G41 which I cant find in Your manual.
Do You have a list of G codes which the CNC supports so I compare with the Hypertherm Edge?
Answer:
Following you may find the requested information.

1, G92 reference point setting
2, G00 air movement
3, G01 straight cut
4, G02/G03 arc cutting
5, G04 pause / delay command
6, G26, G27, G28 return to reference point
7, G22/G80 cycle processing
8, G81 workpiece count

1 M10/M11 gas switch, M10 (on), M11 (off).
2 M12/M13 cutting control valve switch, M12 (open), M13 (off).
3 M14/M15 cutting torch switch, M14 (open), M15 (off)
4 M20/M21 ignition switch, M20 (on), M21 (off).
5 M24/M25 Open preheater valve switch, M24 (on), M25 (off).
6M52 ignition fixed cycle (controlled by time in "cut type")
7M70 cutting gun rise fixed cycle (controlled by time in "cut type")
8M71 torch down fixed cycle (controlled by time in "cut type")
9M72 perforation cutting gun lift fixed cycle (controlled by time in "cut type")
10M73 perforating torch down fixed cycle (controlled by time in "cutting type")
(11) M74 preheating canned cycle (controlled by time in "cutting type")
(12) M80 is always off. After the M80 is executed, all the output ports will be closed.
M07 preheating perforation fixed cycle
2 M08 closed cutting canned cycle
1. Open the height M22
2. Starting arc M12
Close pilot arc M13
2. Turn off the height control M23
3 M02 Program end command.