GSK AC Servo Spindle Motor & Driver

CNC Rebuild Company:
I have a few questions, my apologies if this was previously described in the manual or website.
Is the servo spindle motor and drive provided with the necessary encoder cable to connect to the servo motor to the servo drive?
Is the servo drive provided with the necessary MDR connectors that connect to CN1, CN2, CN3, etc. ?
Is the servo spindle motor provided with the necessary 1200 W / 30 ohm braking resistor?
Is it possible to have the GS3050Y-NP2 servo driver operate at 220VAC, 3 phase?
Would the existing encoder located on the lathe spindle be connected to the servo drive?
Thank you very much for your help.

CNCmakers Support:
Is the servo spindle motor and drive provided with the necessary encoder cable to connect to the servo motor to the servo drive?
Yes, we will provide cables to connect the servo motor to the servo drive.

Is the servo drive provided with the necessary MDR connectors that connect to CN1, CN2, CN3, etc. ?
Yes, we will provide connectors for the servo driver to connect to the CN1, CN2, CN3 of the GSK980TDc.

Is the servo spindle motor provided with the necessary 1200 W / 30 ohm braking resistor?
Yes, we will send braking resistor with the goods.

Is it possible to have the GS3050Y-NP2 servo driver operate at 220VAC, 3 phase?
Yes, we will send GS2050Y-NP2 servo driver operate at 220VAC, 3phase.

Would the existing encoder located on the lathe spindle be connected to the servo drive?
Yes, the existing encoder located on the lathe spindle can be connected to the servo driver.