I. NC ← USB Input
    1.    Create a new folder on the USB flash drive (e.g., named “36M”) and copy the .EIA format program into it.
    2.    Insert the USB flash drive into the machine’s USB port.
    3.    Press the “Data I/O” key on the control panel, as shown below:

    4.    Press the “USB” key.

    5.    Press the “NC ← USB Input” key.

    6.    Press the “Directory Select” key.

    7.    Use the Up/Down arrow keys on the control panel to navigate and select the folder containing the program, as shown below:


    8.    Enter the program number and press the “Start” button.




Note:
If the program format on the USB is not recognized, you can first save any program from NC → USB onto the USB drive, then open it in Notepad and paste your own program into it. After saving, copy it back to the appropriate folder.


II. NC → USB Storage

The steps are almost the same as NC ← USB Input, except you select NC → USB Storage instead of NC ← USB Input.