The original machine tool numerical control system aging failure; ball screw, screw bearing and linear guide rail wear; spindle precision is poor; tool change position is not accurate, the tool cover is damaged; exchange table top flatness; lubrication, cooling, pneumatic System pipeline aging;

The supporting CNC system needs to be replaced to restore the accuracy of the machine and replace the aging parts.

   solution   

The GSK25i CNC system is used, and the servo motor and servo drive are used for transformation;

Replace the linear guides, ball screws and screw bearings; drive the ball screw through a wide range of servo motors; reduce the gap of the drive chain by direct connection;

Overhaul the spindle, replace the spindle bearing, and ensure the spindle accuracy and spindle speed;

Overhaul the tool magazine, fine-tune the tool magazine to close the detection switch position, accept the feedback signal; select the knife reliably, accurately locate, ensure the normal tool change of each station; re-write the T-picture, so that the cutter head can be reversed, the tool is changed nearby, saving time And replace the damaged knife sleeve accordingly;

Re-scraping the workbench: Through the experience of our factory for many years, we will re-scrape the workbench to ensure the flatness of the workbench, thus ensuring the precision of the workpiece.

Overhaul lubrication, cooling, pneumatic systems, etc., replace aging accessories;

Redesign the machine electrical control schematic, replace electrical controls and electrical components and re-route.