Model GDL80-20-24Z/2.2  (PDF file click to download)

Model GDL80-20-24Z/2.2

Voltage 220 V

Power 2.2 kw

Current 7.6 A

Frequency 800 Hz

Rotating speed 24000 rpm

Pole number 4P

Phase number 3

Rotating direction Rotate anticlockwise

from the shaft

extension end

Tool holder IS020 (Parfaite is

recommended)

Blind rivet IS020-15° (Parfaite

is recommended)

Weight 8 KG

 

1: Power line Three-color lines connected with U,

V and W phases/ yellow and green wires grounded

Temperature control line 110°C thermistor two-phase

connected with the temperature-control protector

2: Cooling water feed Pump lift 8m

3: Pole change and dust removal pressure

0.2-0,3Mpa (6/4 hoses)

4: Quantity of proximity switches Pole hanging

and pole discharge NPN (normally open) N.O.

Wiring method of the proximity switch Brown wire

connected with +24VDC blue wire connected with 0VDC

Signal load end connected with +24VDC/the other end

connected with the black wire

5: Air seal pressure 0.1-0.2Mpa (4/2 hoses)

6: Cooling water yielding (2 and 6 ends terminated

with 8/6 hoses)

7: Air inlet pressure of the cylinder 0.65Mpa (6/4 hoses)


 

Special warning:

1. The electric main shaft shall be installed at the clamped position;

otherwise the bearing will be easily damaged!

2. The main shaft shall entirely stop before the tool changing. The

manual tool changing button shall not act during the rotation of the

shaft; otherwise it will easily result in the seizure of the shaft!

3. The compressed air shall be clean and dry, and the filter

accuracy shall be 0.1micron! Air seal is normally open. It is

recommended to use the two-level filter, and the filter accuracy is

0.5 micron/ 0.1 micron respectively. The air filter is installed with the

self-discharge device.